GPS Module Board ublox NEO-6MV2

The  GPS Module Board ublox NEO-6MV2 is the easiest and best GPS module you can add to your project. It includes the GPS antenna and the ublox GPS receiver module. Connect the 4 communication pins (VCC, GND, Tx, RX) directly to your Arduino or any microcontroller, run the example library below and start getting GPS location data’s in minutes. Check out the linked library to get the most out of this GPS and add it to your project very easily.

Note: In the Library below, you can choose to run the example with the “no device” and “with device”. You can also run all by choosing the FullExample.

Note: This module uses baudrate 9600, in the library below find the function setup() and find the code ss.begin(4800); Replace it with ss.begin(9600);. Try the module indoor or outdoor and wait for a while until the GPS locks-in on the GPS satellite and shows you the GPS data.

Features / Specifications

• Power Supply: 3V-5V
• LED signal indicator, With data backup battery
• Module Dimensions: 23mm x 30mm
• Antenna Dimensions: 25mm x 25mm
• Antenna Cable Length: 50mm
• Arduino UART Compatible
• This module has an external antenna and built-in EEPROM.
• Default baudrate: 9600 bps
• Works with standard NMEA sentences

Tutorials / Manuals / Documents

• uBlox GPS Module Example Guide
• Example Code Project for GPS Module ublox NEO6MV2
• TinyGPS++ Arduino Library by mikalhart
• TinyGPS Arduino Library by mikalhart
• TinyGPS on github
• u-blox 6 GPS Modules chip Datasheet
• Example by lastminuteengineers